Most people love using bubble bags. The biggest problem they face is learning to make these bags. This is because they are a bit expensive and some people prefer making them rather than buying them. If you are wondering about the steps to follow, ensure that you get it right. The materials you will need and the steps to follow are listed below here.

What are the materials you will need?

You will require the following materials for you to be able to come up with a good bubble bag:

• Drill that has an attachment of a paint mixer
• Bags
• Frozen trim
• 25-micron press
• Ice
• Paper towel
• Plate
• Bucket preferably (5 gallons)
• Spoon
• Wax paper
• Alcohol
• Water

Now that you have all these materials onset, below are some of the steps that you need to follow:

Step 1

Begin by putting the smallest micron bag into the 5 gallon bucket, follow by adding the following bag size, do this until you fill the bucket to the top. The sizes will depend on the type of pf bag you want to make. For example, if you require a work bag, you can have 25 microns, 73 microns, 120 microns, 160 microns and a 220 micron. These sizes will fill the bucket to the brim.

Step 2

Take another 5-gallon bucket and put ice to fill the bottom of that bucket. Place the bags starting with the smallest bag to the largest. Place the ice into the 220-micron bag. Then pick trim and add it to the 220 micron bag. Do this for all the other bags as you alternate the ice and trim until a few inches to almost the top of the bucket. Fill the bucket with as much water as you can and let it mix for a few minutes. This will give room to the ice water and trim to get cold.

Step 3

After the mix has rested, take 15 minutes and stir the mixture using a drill (the drill with the paint mixer attachment as stated in the requirements). Create foam by moving the mixer all round. This will ensure that the elements in the bucket mix properly. Let this mixture settle for ten minutes. If need be, you can add more ice to this mixture. Stir the mixture for another 15 minutes before letting it settle fully for 20 minutes. All the elements should settle at the bottom of the bags.

Step 4

Slowly remove all the bags one by one, letting the water drip into the next bad until you are done. If there are any extra materials attached to the bag, wipe them off and dry the bottom of the bags using the paper towel. Take a spoon and remove all the materials inside the bags. You can also turn the bag inside out so that you can remove the trichomes easily. Repeat this process all over again for each bag.

Step 5

Freeze the hash in a freezer. Place the bag into a plate and freeze them. After you have done this for all the bags, now spread the mixture out and give it some allowance for it to dry. It will take some time before the hash completely dries out. It might take a week or some days. It is good to wait for long so that there is no room for mistakes.

Step 6

Throw away all the leftover ice and any mess that could have accumulated. Place each bag into a gallon and pour alcohol on to it till the bottom. Let the bags stay for some time, then wash off with water and let it dry.

So, there you have your bubble bag? Making bubble bags is not hard in any way if you follow these steps.